This website requires certain cookies to work and uses other cookies to help you have the best experience. By visiting this website, certain cookies have already been set, which you may delete and block. By closing this message or continuing to use our site, you agree to the use of cookies. Visit our updated privacy and cookie policy to learn more.
This Website Uses Cookies By closing this message or continuing to use our site, you agree to our cookie policy. Learn MoreThis website requires certain cookies to work and uses other cookies to help you have the best experience. By visiting this website, certain cookies have already been set, which you may delete and block. By closing this message or continuing to use our site, you agree to the use of cookies. Visit our updated privacy and cookie policy to learn more.
In order to obtain steel with high tensile strength and elongation and good pitting resistance, the economical duplex stainless steel with and without the addition of tungsten was prepared in this paper.
Reverse engineering is conducted based on the analysis of an already existing product. The results of such an analysis can be used to improve the functioning of the product or develop new organizational, economic, information technology and other solutions that increase the efficiency of the 3D-printed products.
The steel industry is responsible for one-third of all global industrial CO2 emissions, putting pressure on the industry to shift forward toward more environmentally friendly production methods. This review focuses on the current developments over the last 10 years in the steelmaking industry.
This paper discusses the effect of different heat-treatment procedures on the microstructural characteristics, damping capacities and mechanical properties of CuAlNi shape memory alloys (SMA).
In this paper, the microstructures and rolling contact fatigue behaviors of laser cladding Inconel 625 coatings with or without post-heat treatments were analyzed.
The recovery and reuse of waste printed circuit boards (PCBs) has attracted more and more attention from global researchers. This white paper puts forward a clean and economical method in which enhanced gravity separation and wet high-gradient magnetic separation were combined to recover waste PCBs with heat treatment at a temperature of 464°F (240°C). The heat treatment could improve the metal liberation effect of the PCBs.
The precipitation-hardenable aluminum alloy 6061 (AA 6061) is favored for aerospace components and automotive parts. However, the tenacious oxide layer on the surface greatly limits the quality and applicability of joining AA 6061. This paper investigates the joining method of solid-state diffusion bonding for AA 6061 plates and the effects of post-weld heat treatment (PWHT) on the joint interface.
This white paper investigates the effect of solution heat treatment as well as primary and secondary aging treatment conditions on the microstructural evolution of a high-entropy superalloy.
Selective laser melted (SLM) IN718 alloy specimens are subjected to heat treatment and shot peening to assess the effect of post processing on the corrosion performance of the alloy in a 3.5 wt % NaCl solution.